EarthWise LST04012 Manual De Uso página 8

Charge the battery pack only with the charger provided.
Allow at least 75 minutes of charge time for 2Ah battery or
120 minutes of charge time for 4Ah battery before initial
use of the string trimmer.
Make sure the power supply is normal household voltage,
120volts, 60Hz, AC only.
The battery charger should be operated in temperatures
between 32 and 100 degrees F.
The battery should be charged in a cool, dry place.
2 to 3 initial charging/discharging cycles may be required to
achieve maximum run time/capacity.
Do not attempt to open the charger or the battery. There are
no customer serviceable parts inside. Call the customer ser-
vice help line at 1-800-313-5111 for assistance.
DO NOT incinerate battery packs even if they are severely
damaged or completely worn out. They can explode in a fire
causing injury.
Use the battery charger indoors only.
Disconnect charger from the power supply when not in use to
prevent damage to the charger during a power surge.
When fully charged, the battery can be safety stored in
temperatures down to –4° degrees F for a period of up to
CAUTION: Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc., come in
contact with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
Make sure the battery is detached from the unit, then use
only mild soap and a damp cloth to clean the tool. Never let
any liquid get inside the tool; never immerse any part of the
tool into a liquid.
Fertilizers and other garden chemicals contain agents which
greatly accelerate the corrosion of metals Do not store the
tool on or adjacent to fertilizers or chemicals.
Problem Possible Couse
-Unit does not Run -Battery not making contact
-Tripper switch not operational
-Battery not installed properly
-Battery not charged
-Line won't feed -Line tangled in spool
-Line fails to cut off -Line cutting blade in guard is damaged or
missing
-Battery will not charge -Battery not inserted into charger
-Charger not plugged in
-Surrounding air temperature too hot or too cold -Move charger and tool to a surrounding air temperature of about 32
CHARGING THE BATTERY PACK
MAINTENANCE
TROUBLESHOOTING
CALL US FIRST !!
Call us first with questions about operating or maintaining your string trimmer
at 1.800.313.5111 between 8:00AM-5:00PM Eastern Standard Time,
or send emails to earthwise@reelin.com.
four weeks, before requiring charging.
Fully charge battery pack every 90 days.
If over a period of time the battery pack quickly runs down
after a full 75 or 120 minutes charging period, a replacement
battery pack is needed.
To prevent permanent damage to the battery, never store in a
discharged condition.
WINTER STORAGE—Fully recharge before storage and then
again every 90 days.
Since the battery will not develop a memory, it does not have
to be fully discharged before recharging.
A small leakage of liquid from the battery cells may occur
under extreme usage, charging or temperature conditions.
This does not indicate a failure. However, if the outer seal is
broken and this leakage gets on your skin.
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or
vinegar.
c. If the battery liquid gets in your eyes, flush them with
clean water for a minimum of 10 minutes and seek
immediate medical attention.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
a qualified individual using only identical replacement parts.
If you drop the trimmer, carefully inspect it for damage. If the
guard is bent or cracked, handles broken or if you see any
other condition that may affect the trimmer's operation, it must
be repaired before putting it back into use. Call our customer
service help line at 1-800-313-5111 for assistance.
Possible Solution
-Check battery is fully inserted
-Check that lock off button is fully forward prior to moving trigger
-Check battery installation
-Check battery charging requirements
-Unwrap 12" or more of line and re-wind
-Replace guard
-Insert battery into charger until green LED appears
-Plug charger into a working outlet
-Check current at receptacle by plugging in a lamp or other appliance
-Check to see if receptacle is connected to a light switch which turns
power off when you turn out the lights
degree F (0 degree C) or below 100 degree F (+37.8 degree c)
8