Names And Functions Of Parts - Teac CG-10M Manual Del Usuario

Front
A
Rear
A
POWER switch
Use to turn the unit on and off.
B
Meter (OVEN)
This shows the operation status (heater output) of the oven
in the OCXO. When the power is turned on, movement of the
meter needle will be unstable. After about two minutes, how-
ever, it will stop between 0 and 6, allowing you to confirm that
the temperature has become stable. (The position at which the
needle stops will vary according to the ambient temperature
where the unit is located.)
o Even after two minutes have passed, operation to further
increase stability will occur following temperature changes
inside the oven. For this reason, we recommend allowing
it to warm up for about 10 minutes before actually using it.
C
Meter brightness knob (
Use this to adjust the brightness of the meter.
)

Names and functions of parts

B
C
Meter indicator example
OCXO
heater
output
(STATUS)
2
OCXO
The master clock that provides the reference for this unit con-
tains an oven-controlled crystal oscillator (OCXO). This OCXO,
which actually has both a crystal oscillator and an electronic
oscillator inside a compact oven, achieves extremely high fre-
quency stability.
10 (minutes)
Elapsed time
EN
7