Robby G3 Instrucciones De Uso página 10

2. Functional parts:
1. Connecting tube
2. Adaptor clamp
3. Suction hose (not included in the delivery package)
4. Handle
5. Turning knob (speed indicator)
6. Turbine
7. Gear unit
8. Driving wheel unit
9. Bottom with brushes
10. Big pre-filter for large debris
11. Back wheel
12. Flaps
English
10
Robby G3
The pool-vacuumer Robby G3 truly works fully automatically!
l
Brushes and vacuums the bottom of the pool, most of all the dirty areas
in corners and edges.
l
Is made for pools of any shape or size built of any material - needs no
special adjustments.
l
Works without electricity. While the Robby G3 is cleaning, you can have
a safe swim in the swimming-pool.
l
Has a built in pre-filter.
l
Cleans when the pool is covered too.
1. Limitations:
l
Required capacity of the filter should be bigger than 18 gal/min.
l
Up to 20% maximal slope of the pool-bottom.
l
Runs most economically in pools of a maximum of 25 yd length.
3. Using the Robby G3
1.The handling is child's play. It essentially functions like a manual vacuum.
2. Fully switch the water-flow from the drain to the skimmer
3. Attach the suction hose (3) to the connecting tube (1) of the
Robby G3, and if required, secure it with the adaptor clamp (2).
4. Whilst holding the suction hose (3) let the ROBBY G3 sink to the
pool-bottom.
5. Fill the suction hose (3) with water and plug it into the skimmer or into
the specially provided plug (Hint: To fill the suction hose you can hold it
against an inlet jet-stream for a couple of seconds, until there are no
rising air-bubbles visible anymore).
6. Robby G3 starts to work.
4. Cleaning:
The cleaning-time depends on both the size of the pool and how dirty it is.
For example: Pool of 13x26 ft. approx. 3 hours.
After cleaning:
1. Pull the suction-hose off the skimmer or the suction-plug.
2. Return the drain to its previous position.
3. Drag the Robby G3 out of the water, grab the handle and tilt the
Robby G3 backwards allowing the water to flow out of the Robby G3
through the flaps (12).
4. From time to time the pre-filter 10) needs to be emptied. To do so,
remove the bottom (9) by loosening the 3 wing-nuts. The dirt can be
rinsed off using an ordinary garden-hose.
5. Do not store the ROBBY G3 in water, as this will affect the life span of the
gear unit.