System Settings - DRYDEN AQUA DA-GEN Manual Del Usuario

Water adjustments
Adjust the alkalinity between 100 and 200
1
ppm.
Adjust the pH to 7.4.
2
Adjust the chlorine between 0.1 and 0.5
3
ppm.
Attention: Do not calibrate free chlorine with a chlorine
level of less than 0.3 ppm free chlorine!
6.1
6.6
6.10
7. PADDLE FLOW SWITCH
Paddle flow switch. Stops
the hydrolysis and the
dosing pumps if there is
no water flow.
Paddle Flow switch
9.1
9.1 Hydrolysis: Programming
of hydrolysis functions
5. INITIAL WATER ADJUSTMENTS
Adding activator/salt to the water
We recommend to add 1 to 2 kg magnesium chloride (MgCl
1
of normal salt (NaCl) per m
recommended to mix them, for example in a ratio 1:3 (MgCl
Add the magnesium chloride or salt directly to your swimming pool and let the
2
system run.
In outdoor pools it is necessary to use ACO

6. SYSTEM SETTINGS

6.2 6.3
6.7 6.8
6.11 6.12
Connect as shown in the image
1
and contact your installer for
2
activation.
3
4
5
6
7
8
FL1 2 5
&
9. HYDROLYSIS
9.2 Level:
Hydrolysis - Desired disinfection
production (Always 100%).
3 of water. The TDS should be at around 1200. It is
® .
6.4
6.9
6.9 Sound
6.11 Password: Protect the user´s menu by activating a password.
To enter your password press a combination of 5 keys and the
system will memorise them. If you forget the password, there is a
"master password". Ask your installer/provider.
6.13
2x
8. SUCTION LANCE (pH BOTTLE)
Connect the suction lance. The installer/provider
3
should be contacted to activate the sensor.
4
5
6
pH-Minus bottle
level
TANK
4 & 5
9.2
3
) or 0.75 - 1.5 kg
2
:NaCl).
2
6.5
6.3 Language
6.5 Date and Time
6.7 Display brightness
6.14
6.12 Hydrolyse-Cell working hours
6.14 System info: Information about
the software versions and the ID node
9.3
9.3 Mode: If the device has Free Chlorine
and redox probes, choose the parameter
that controls the cell's chlorine generation.
EN