Safety Instructions - Premier ED-5138 Manual De Instrucciones

-bed and breakfast type environments.

Safety instructions

1. Always operate the appliance on an even surface .
that the hot steam can disappear.
2. The temperature of the outer surface may be high when the appliance is working. Please do not
touch outer surface by you hand.
3. To avoid the danger of fire ,never leave the appliance unattended.
Operating instructions
1. Uncoil the cable completely
2. Check if the heating plates are clean and dust-free. if necessary ,wipe them with a damp cloth
3. Place the device on a heat-resistant surface
4. Please ensure that the temperature regulator is turned to 0 OFF and insert it into the socket of the
thermostat. if the thermostat is not inserted correctly ,this may lead to abnormal heating, in which
case the consequence may be damage or accidents.you should therefore ensure that the thermostat
is inserted correctly.
5. connect the device to properly installed 220~240V,50Hz power socket
6. Set the temperature control according to what you intend to do .Adjustment Temperature adjustment
in °C approx.use:
1 Keeping warm
2 Over 100°C Simmering
3-4 150°C -200°C Stir-frying
5 More than 200°C grilling
7. the device has reached the correct temperature when the control lamp on the thermostat goes off.
During operation the control lamp goes on from time to time to show that the correct temperature is
being maintained.
8. During use,Excess fat will flow through the drain holes into the drip tray
9. After using, pull out the plug .
Caution:
1. The first heating process should take place without any foodstuffs, let it heat for about ten minutes.
There may be a slight development of smoke or smell. This is normal and harmless
2. Never use sharp fork or knife to remove the food as this would damage the non-stick coating of
cooking surface. Use heat-resistant wood or plastic utensils only.
3. Always unplug the appliance from the power socket when not in use.
4. Before inserting or removing the thermostat,please ensure that the scale of the temperature
regulator is turned to (OFF).otherwise the device may if fail to operate or overheat
5. keep the temperature sensor and the pins of the holder clean
Make sure that there is enough ventilation, so
P-3