General Safety Warnings - Kreg Tool True-FLEX PRS3010 Manual Del Propietário

WARNING
WARNING
• Read, understand, and follow your power tool manufacturer's safety instructions.
Keep all tool guards and safety devices in place.
• Always wear eye and ear protection. Use respiratory protection in dusty conditions.
• Disconnect power tools from the power supply before making any adjustments to the tool or accessories.
• Always mount the featherboard with the "DIRECTION OF FEED" arrow pointing in the same direction that the
workpiece will be fed into the cutting tool.
• Make sure the featherboard is securely anchored in the T-track or miter-gauge slot and will not move while in use.
• Do not attempt to compensate for warped, twisted, or bowed workpieces by applying pressure with a featherboard.
All workpieces must have flat faces and square edges.
• Keep hands away from cutting tool edges and your body out of the path of the cut. Always use a push stick.
• Always use sharp cutting tools with adequate clearance between the cutting edge and the body of the tool.
Dull tools or tools without adequate clearance increase the risk of kick-back.
• Do not operate tools or machinery while under the influence of drugs, alcohol, or medications.
• Do not allow familiarity gained from frequent use of your tools to replace safe work practices.
A moment of carelessness is sufficient to cause severe injury.
WARNING:
This product can expose you to chemicals including Acrylonitrile and other chemicals, which are known
to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.
Knob
Washer
T-Track Bolt

General Safety Warnings

Read, understand, and follow the safety warnings and instructions in this manual.
Failure to do so may result in serious injury or death.
The Kreg True-FLEX™ Featherboard is not an anti-kickback or safety device and
does not replace the safety devices included with your power tool.
T-Track or T-Slot
Assembly
T-Track or T-Slot