Controls, Alarms And Indicators; Controls - GETINGE GROUP ARJOHUNTLEIGH Alpha Active 4 Instrucciones De Uso

4. Controls, Alarms and Indicators

Controls

Cycle Time
Min
Kg
Patient Weight Selector
On/Off Button
Alarm Mute
Mode Select
Auto-firm Mode
Patient Weight Selector
Kg
Cycle Time
Min
Alarm Mute
On/Off
Pressing the
switch will illuminate when the pump is on.
During an alarm condition the sound of the alarm can be
muted by pressing this button. The yellow indicator will
then remain on but the alarm will be muted.
The mode selector allows the mode of operation to be
selected.
Two modes of operation are available, Alternating or
Static (non-alternating). The indicator next to the
respective icon indicates the currently selected mode.
Auto-firm
Selects the
indicator will illuminate when the pump is in this mode.
Auto-firm
lasts 30 minutes, after which the pump will
default back to the previous setting.
Two buttons (+ and -) are used to select the patient
weight. This sets the pressure inside the mattress
replacement and therefore the amount of support the
patient receives. The patient weight setting may be
affected by a power fail event. See Power Fail on
page 8.
The pressure setting is indicated by the green indicator
above the selected setting.
A single button allows the cycle time to be selected for
patient and/or clinician preference.
The cycle time setting is indicated by the green indicator
above the selected setting.
7
Mode Select
Alarms
button will activate the pump.The
, non-alternating mode. The orange
Auto-firm Mode