PCi Express Card
PCIe to USB 3.0 adapter is PCIe x1 card with 2 external and 2 internal USB 3.0
ports (all of them are back compatible with USB 2.0 and USB 1.1). It is Fully
compliant with PCI Express Base Specification Revision 2.0. Adapter supports
simultaneous operation of multiple USB 3.0, USB 2.0 and USB 1.1 devices with
up to 5 Gbps speed data rate. Built-in 4-pin power slot for receiving extra power
supply from system.
PACKAGE CONTENTS
• 1 x PCIe to 2x external + 2x internal USB 3.0 adapter
• Extra Low Profile Backplate
• 1 x User Manual
FEATURES
• Fully compliant with PCI Express Base Specification Revision 2.0
• Compliant with Universal Serial Bus 3.0 specification Revision 1.0
• Single-lane (x1) PCI Express throughput rates up to 5 Gbps
• Supports simultaneous operation of multiple USB 3.0, USB 2.0 and USB
1.1 devices
• Supports the following speed data rates as follows:
• Low-speed (1.5 Mbps) / Full-speed (12 Mbps) / High-speed (480 Mbps) /
Super-speed (5 Gbps)
• Built-in 4-pin power slot for receiving extra power supply from system
• Hot-swapping feature allows you to connect/disconnect devices without
powering down the system
• Support Windows® 7 / 8 / 10 (32/64 bit)
SYSTEM REQUIREMENTS
• Installed Windows 7 / 8 / 10 (32/64bit)
• One available PCI Express slot (Recommend PCI Express 2.0)
• One available Molex connector on PSU
INSTALLATION
Hardware installation:
Attention! The adapter can install skilled person or authorized service depart-
ment only. i-tec Technologies, s.r.o. is not responsible for damages caused by
unauthorized assembling and installation of this device.
• Turn Off the power to your computer.
• Unplug the power cord and remove your computer's cover.
• Remove the slot bracket from an available PCIe slot.
• To install the card, carefully align the card's bus connector with the select-
ed PCIe slot on the motherboard. Push the board down firmly.
• Replace the slot bracket's holding screw to secure the card.
4 |
ENGLISH