Safety Instructions - i-tec MySafe TB3MYSAFEM2 Manual De Instrucciones

FORMATTING A NEW HDD
1. Click with the right button on „Desktop".
2. Select „Administrate".
3. Click on „Disc administration".
4. Select HDD with the marking „Unassigned" or „Uninitialized" and with the
specified capacity of the inserted disc (usually a number lower by same digit
places is displayed).
5. Provided the disc is not initialized, click on the left field by the right button
and select „Initialize disc".
6. Click with the right button on the area of the disc and select „New simple
bunch", click on „Next".
7. Leave the maximum bunch size and click on „Next".
8. Select „Assign a letter of the unit" and click on „Next".
9. Select „Format the bunch with the following setting" (leave the initial
settings). Click on „Next" and „Finish".
10. HDD will be formatted. The duration of formatting depends on the HDD size;
afterwards the HDD will be viewable in the system.

SAFETY INSTRUCTIONS

• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping and falling
to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the user manual.
FAQ
Available on our website www.i-tec.cz/en/ on the „FAQ" tab of this product.
Quick Start
| 5
ENGLISH