Tool Lubrication - RotoZip RZ1 Instrucciones De Funcionamiento

RZ 2610938267 02-07
Step 2: Slide switch to turn the tool on.
While holding the spiral saw firmly with both
hands, plunge the XBit through workpiece
anywhere inside the closed loop of the
template. Guide the tool to the right until you
feel and hear the XBit touch the inside edge
of the template.
Step 4: Continue to follow the inside of the
template, always maintaining light pressure
in the direction of the template as you cut in
a clockwise direction. Be prepared to
support the scrap piece being removed with
a second person, or make the cut-out such
that gravity pulls the scrap piece away from
you and the tool.
Preventive maintenance
WARNING
!
performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause
recommend that all tool service be
performed by a Bosch Factory Service
Center or Authorized Bosch Service Station.
3/1/07 8:52 AM
Maintenance
Service
serious hazard.
Page 13
Step 3: While keeping the XBit in contact
with the template, move the tool clockwise
while applying light outward pressure until
you feel and hear it come to a corner. As
you round the corner, continue to apply light
outward pressure toward the template.

TOOL LUBRICATION

Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
We
CHUCK LUBRICATION
The wrenchless chuck has been properly
lubricated and is ready to use. If the chuck's
jaws begin to stick during use, the chuck
-13-