Hema 80.01.0099 Manual De Instrucciones página 20

PARTS IDENTIFICATION
1. Temperature regulator
2. Burst of steam button
3. Spray button
4. Spray nozzle
5. Water inlet cover
6. Indicator light
7. Steam control knob
8. Soleplate
9. Water tank
10. Self-clean button
BEFORE INITIAL USAGE
Remove all packaging material. Make sure the appliance is unplugged and the temperature regulator is set at
position "OFF".
Open the water inlet cover and fill water into the opening up to the max level marked on the water tank. For
this, use the measuring cup. Do not use chemically de-calcified water.
Insert the power plug into a designated outlet and set the temperature regulator on the highest temperature
setting. After the indicator light goes off, set the steam control knob to your desired position and iron on an old
piece of cloth to remove possible residue.
With first use, there can be slight odour or smoke, but this is harmless and only of short duration. Make sure
there is adequate ventilation.
OPERATION
Before selecting the temperature, read the instruction manual for the iron or the care advice on the tag of the
clothing.
Note: If there is no care advice on the piece of clothing, then you should begin ironing with the lowest
temperature. With lower temperature, there will be less steam.
OFF
●
●●
●●● MAX
DRY IRONING

Connect the iron to a suitable mains supply outlet.

Ensure that the steam control knob is in position "

Select the setting on the temperature regulator.

When the indicator light goes off, the required temperature is reached. The iron is ready for use.

To turn off the iron, turn the temperature regulator counter-clockwise to position "OFF", set the iron upright,
and pull out the power plug.
STEAM IRON
Fill the water tank, as described before initial usage.
Steam ironing can be used in the temperature ranges ●, ●●, ●●● MAX. For the reliable functioning of the steam
ironing, the water tank must be at least ¼ filled.
Spraying function: Press the spray button to moisten a spot to be ironed. Water will come out of the spray nozzle.
Steam Function: Turn the steam control knob to the required position, after preheating the steam iron first,
steam starts coming out from the holes in the soleplate.
Burst of steam: Turn the temperature regulator to the position "MAX". The indicator light will go off when the
required temperature is reached. Then press the burst of steam button. This function provides an extra amount
of steam to remove stubborn wrinkles. For optimal use, please allow the appliance to have a rest of 3 - 5 seconds
between each press.
Off
Nylon
Wool, silk
Linen, cotton, highest temperature
".
- 19 -