General Safety Instructions; Intended Use; Installation - Dometic ECO Holding Tank Vent Filter Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ECO Vent Filter
2

General safety instructions

The manufacturer will not be held liable for claims for damage resulting from the following:
Faulty assembly or connection
Damage to the unit from mechanical influences
Alterations to the unit without express written permission from the manufacturer
Use for purposes other than those described in the operating manual
3

Intended use

When a toilet is flushed on a boat with a holding tank, air is pushed out of the holding tank, through
a vent hose, and out of the boat through a vent fitting . To stop foul-smelling air from coming out of
the vent fitting, install an ECO Vent Filter .
4

Installation

Remove old filter (if replacing existing vent filter)
1 . Remove vent hose from both ends of old vent filter . If old vent filter was connected to threaded
fittings for 5/8-in ./16 mm or 3/4-in ./19 mm ID hose, those fittings should remain attached to vent
hose .
2 . Remove old filter from bracket and seal ends with adhesive tape .
3 . Discard old filter in appropriate container .
Install filter
NEW INSTALLATION
1 . Select location for vent filter . Avoid areas near excessive heat sources (engine manifolds,
lights, etc .) . Do not install filter below top of holding tank (fig .
2 . Vent filter can be mounted at any angle . Installations near thru-hull vent reduce chance of filter
damage from potential overfilling of tank .
3 . Install mounting bracket (fig .
4 . Lightly lubricate O-rings on each end of filter cartridge with silicone grease .
5 . Remove red plugs from each end .
6 . After vent hose ID is chosen, attach correct size hose adapters (fig .
cartridge with retaining fasteners (fig .
over O-rings before threading the retaining fasteners to the filter . Refer to Adapter Size Chart
below to identify correct size hose adapter .
7 . Press ECO vent filter (fig .
8 . Route vent hose from waste holding tank and thru-hull fitting to ECO vent filter . Using hose
clamps (not included), attach vent hoses to adapters that are connected to vent filter .
Adapter Size Chart
Ref.
Description
4
Retaining fasteners
5a
threaded adapters for 5/8-in . or
3/4-in . ID hose threaded fittings
5b
5/8-in .+ 3/4-in . ID hose adapters
5c
1-in .+ 1 .5-in . ID hose adapters
2
1, p . 2) with screws (fig .
4, p . 2) . Be sure to push hose adapters completely
3
6, p . 2) into mounting bracket so that it clicks into bracket arms .
3
(fig .
, p . 2)
3
General Safety Instructions
p . 2) .
1
2
2, p . 2) .
3
5b
5c
5b or 5c, p . 2) to filter
Hose adapter
connection zones for:
5/8 in ./16 mm ID hose
3/4 in ./19 mm ID hose
1 in ./25 mm ID hose
1 .5 in ./38 mm ID hose
5

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido