Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• There is water in the mixture. Drain and rinse
all the fuel system.
• The air filter is dirty. Clean the air filter.
• There are carbon deposits in the cylinder
exhaust pipe or the muffler. Clean those or
change the muffler.
STARTING A FLOODED ENGINE
• Disconnect the spark plug lead, and use the
plug wrench to remove the spark plug in a
counter clockwise direction.
• If the spark plug is fouled or is soaked with
fuel, clean or replace the plug as required.
• Clean excess fuel from the combustion cham-
ber by cranking the engine several times while
the spark plug is removed.
• Install the spark plug and firmly tighten it
with the spark plug wrench.
• Repeat the starting procedure as if the blow-
er was already warm.
IF THE ENGINE WON'T STOP
• If the engine continues to run after switch-
ing the on/off switch to off, stop the engine
by pushing the choke lever to the fully closed
position. If this condition continues, have the
blower serviced before using it again.
14
TECHNICAL DATA
DISPLACEMENT
GAS TANK CAPACITY
NO LOAD SPEED
AIR SPEED
AIR VOLUME
WEIGHT
COLLECTOR CAPACITY
30 cc
500 ml
7 500 r/min
450 Km/h
459 CFM (13 m³/min)
7 kg (15,4 lb)
Publicidad
Tabla de contenido
