Troubleshooting; Technical Data - Surtek SAG532 Manual De Usuario

4. Clean and adjust the
spark plug gap to 0.6 -
0.7mm.
5. Replace any damaged
or visibly worn plug with
a TORCH L8RTC or equiva-
lent spark plug.
6. Install the spark plug finger tight in the cyl-
inder head, and then tighten it firmly with the
spark plug wrench.
VACUUM BAG
A dirty bag will reduce performance. To clean
the bag, turn it's inside out and shake. Wash
the bag in soapy water. Clean the bag at least
once a year.

TROUBLESHOOTING

POWER LOSS OR SUDDEN STOPPING OF THE
ENGINE
• Check whether the fuel tank is empty.
• The mixture does not reach the carburetor.
Clean the fuel filter in the fuel tank.
• There is water in the mixture. Drain and rinse
all the fuel system.
• The air filter is dirty. Clean the air filter.
• There are carbon deposits in the cylinder
exhaust pipe or the muffler. Clean those or
change the muffler.
STARTING A FLOODED ENGINE
• Disconnect the spark plug lead, and use the
plug wrench to remove the spark plug in a
counter clockwise direction.
• If the spark plug is fouled or is soaked with
fuel, clean or replace the plug as required.
• Clean excess fuel from the combustion cham-
ber by cranking the engine several times while
the spark plug is removed.
• Install the spark plug and firmly tighten it
with the spark plug wrench.
• Repeat the starting procedure as if the blow-
er was already warm.
IF THE ENGINE WON'T STOP
• If the engine continues to run after switch-
ing the on/off switch to off, stop the engine
by pushing the choke lever to the fully closed
position. If this condition continues, have the
blower serviced before using it again.
E N G L I S H •

TECHNICAL DATA

DISPLACEMENT
GAS TANK CAPACITY
NO LOAD SPEED
AIR SPEED
AIR VOLUME
WEIGHT
COLLECTOR CAPACITY
U ser's manual
32 cc
500 ml
7 000 r/min
200 Km/h
353 CFM (10 m³/min)
7,5 kg (16,5 lb)
40 L
15