Factory Reset - Corsair Gaming K55 Guia De Inicio Rapido

5
Dynamic lighting modes 9 through 12 can be further customized with various speed and/or
direction modes.
MODES
FN KEY COMBO
9 10 11 12
Y Y Y Y FN + Up Arrow
Y Y Y Y FN + Down Arrow
N N Y Y FN + Left Arrow
N N Y Y FN + Right Arrow
CUSTOMIZE BACKLIGHTING
Each of three RGB backlighting zones on K55 RGB can be individually customized with one of the
8 predefined colors and saved as a custom lighting mode (FN + 7) . After making selection for all
three zones separately, press and hold FN + 7 key combination for 3 seconds. All 3 zones will blink
rapidly twice in selected colors to confirm the custom static mode has been saved.
FN KEY COMBO
FN + F1
FN + F2
FN + F3

FACTORY RESET

Press and hold FN + F4 for 5 seconds. All 3 zones will blink rapid 2 times in white color to confirm
all lighting modes and macro assignments have been reset to defaults.
FUNCTION
Increase speed (Fast -> Medium -> Slow)
Increase speed (Slow -> Medium -> Fast)
Change direction from light to left
Change direction from left to right
FN KEY COMBO
Zone 1 — RED / GREEN / BLUE/ YELLOW / CYAN /
PURPLE / ORANGE / WHITE / OFF
Zone 2 — RED / GREEN / BLUE/ YELLOW / CYAN /
PURPLE / ORANGE / WHITE / OFF
Zone 3 — RED / GREEN / BLUE/ YELLOW / CYAN /
PURPLE / ORANGE / WHITE / OFF
NOTE ON ENVIRONMENTAL PROTECTION
After the implementation of the European Directive
2002/96/EU in the national legal system, the
following applies:
—Electrical and electronic devices may not be
disposed of with domestic waste.
—Consumers are obligated by law to return
electrical and electronic devices at the end of their
service lives to the public collecting points set up
for this purpose of point of sale. Details to this
are defined by the national law of the respective
country. This symbol on the product, the instruction
manual or the package indicates that a product is
subject to these regulations. By recycling, reusing
the materials or other forms of utilizing old devices,
you are making an important contribution to
protecting our environment.
CAUTION!
The manufacturer is not responsible for any
radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications
could void the user authority to operate the
equipment.
FCC STATEMENT
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
> Reorient or relocate the receiving antenna.
> Increase the separation between the equipment
and receiver.
> Connect the equipment into an outlet on
a circuit different fromthat to which the receiver
is connected.
> Consult the dealer or an experienced radio/TV
technician for help.
This device must not be co-located or operating
in conjunction with any other antenna or transmitter.
Operation is subject to the following two conditions:
(1)this device may not cause harmful interference,
and (2)this device must accept any interference
received, including interference that may cause
undesired operation.
!