Technical Information - FERVERD GQ01023 Manual De Instrucciones

If a replacement is necessary, please contact either our Customer Service Department or your local
dealer. The use of unauthorised parts can create unsafe conditions and environment.

TECHNICAL INFORMATION

Appliance code
Total heat input (all gas
categories)
Gas category
Type of gas
Gas pressure
Injector size
Identification code
Serial number date code
Ignition: Main burner: Single shot piece ignition unit
IMPORTANT
Read the following instructions carefully and be sure your barbecue is properly installed, assembled
and cared for. Failure to follow these instructions may result in serious bodily injury and/or property
damage.
If you have any questions concerning assembly or operation, consult your dealer or LPG Gas
Company.
When used on the ground always place the appliance and cylinder on flat level ground.
Never light the appliance with the HOOD in the closed position.
Your barbecue can be used on gas cylinders between 11 kg and 15 kg. Your barbecue will perform
better if propane or LPG mixtures are used. Butane can be used but because of the rate of the
appliance the cylinder will tend to freeze and supply gas at reduced pressures affecting the
performance of your barbecue.
When sitting the barbecue the following clearances must be obeyed:
Sides and rear of appliance: 1 meter from any obstruction. Above the appliance: NO OVERHEAD
OBSTRUCTION ARE PERMITTED.
NOTE FOR CONSUMER
Retain for future Reference
CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane or propane gas or LPG mixtures,
fitted with the appropriate low-pressure regulator via a flexible hose. The hose should be secured to
the regulator and the appliance with hose clips. This barbecue is set to operate a
28 mbar regulator with butane gas and a 37 mbar regulator with propane gas 30 mbar for LPG
mixtures, or 37 mbar for LPG mixtures, or 50 mbar for LPG mixtures. Use a suitable regulator
certified to BSEN 12864: 2001. Please consult your LPG dealer for information regarding a suitable
regulator for the gas cylinder.
REGULATOR AND HOSE
These items are NOT supplied with the barbecue, but replacements are available from your
equipment retailer or an authorised LPG gas stockist. Use only regulators and hose approved for LP
Gas at the above pressures. The life expectancy of the regulator is estimated as 10 years. It is
recommended that it the regulator is changed within 10 years of the date of manufacture.
GQ01023
5.50 kW (393 g/h)
I
3+(28-30/37)
Butane Propane
28-30 mbar 37 mbar
Main: 0.84 mm
359BU1048
Appliance code-09-0000000
I
3B/P(30)
LPG GAS MIXTURES
30 mbar
Main: 0.84 mm