Craftsman 580.752880 Instrucciones De Uso página 15

Cleaning andApplying Detergent
AWARNIN6 Chemical Burn Hazard.
j_, Chemicals could cause burns resulting in death,
serious injury, and/or property damage.
• DONOT usecausticliquid with pressure washer.
• UseONLYpressure washersafedetergents/soaps. Followall
manufacturers i nstructions.
To apply detergent,follow these steps:
1. Review use of selector nozzle.
2. Remove cap and screw PerfectMix
TM
Extreme
Concentrate bottle onto right underside of Quick
Switch
TM
assembly. Repeatfor second bottle on left side.
NOTICE Make sure clear detergent tube is inserted into
PerfectMix
TM
Extreme Concentrate bottle when screwing onto
Quick Switch
TM
assembly.
3. Turn Quick Switch
TM
to select desired detergent.
4. Make sure SOAPspray pattern nozzle is selected on
selector nozzle.
NOTICE Detergent cannot be applied with the MAX,
GENERAL,DELICATE or FLUSHspray pattern nozzles.
5. Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ON could damage the pump.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
6. Start engine following instructions How to Start Your
Pressure Washer.
7. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
8. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as neededto prevent
surface from drying. DO NOTallow detergent to dry on
(prevents streaking).
Pressure Washer Rinsing
For Rinsing:
1. Select and change to desired spray pattern nozzle on
selector nozzle.See How To Use Selector Nozzle.
2. Keep spray gun a safe distance from area you plan to
sp ray.
,& WARNIN6 Kickback from spray gun could cause you
to fall resulting in death or serious injury.
• Operate pressure washer from a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding, or any other similar location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
3. Apply a high pressure spray to a small area and then
check surface for damage. If no damage is found, you
can assume it is okay to continue rinsing.
4. Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Automatic Cool DownSystem(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F. The system engages to cool the pump by discharging
the warm water onto the ground.
15