Placement And Mounting - Ecler NEST106 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. PLACEMENT AND MOUNTING

Consider following general rules:
Place the cabinets on solid and firm surfaces.
No obstacles should stand between the cabinets and the audience.
Although the speakers can be used outdoors, they should not be directly exposed to
sunlight or rain.
Always adjust the output sound pressure levels to the reproduction requirements. Despite
their small size, they can produce significantly higher pressure levels than home speakers.
The NEST106 packaging contains everything you need to install the cabinet:
Two metal wall mount guides (one per cabinet).
Eight screws and eight 6 mm wall anchors (four per cabinet).
Two M6x30 DIN912 screws (one per cabinet).
One M6 Allen wrench.
Two terminal block connectors (one per cabinet).
An instruction manual.
A warranty certificate for each cabinet.
Screws, washers and nuts to join the mount guides
Individual corner installation procedure:
1.
Drill two 6 mm holes in each wall of the corner where you would like to install the cabinet.
Use the metal guide as a template to mark the positions.
2.
Insert four 6 mm wall anchors in the holes.
3.
Put the metal guide in place. Insert and tighten the screws supplied.
4.
Use the terminal block connector to connect the speaker cable to the connector on the
back part of the cabinet. Make sure to line up the right polarity on the terminals and make
sure the cable goes through the square hole on the mount guide.
5.
Put the cabinet in its final position and use one of the M6 screws to fix the metal guide in
place. To do so, you must first remove the metal grille on the front panel.
6.
Set the power switch to the desired position.
7.
Replace the metal grille.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido