Foscam FI9816P Manual Del Usuario página 12

Setup
1
Camera Setup
1 P ower Supply - Using AC Power
.1
Plug one end of the provided power adapter into a wall outlet and the other end
into the back of the camera. See Fig. 3.
Note 1: Use the adapter labeled OUTPUT: 6V DC with the camera.
Note 2: Press and hold the Power button over two seconds to turn off the
1
Fine Tuning
.2
Place the camera in a convenient location, point the lens toward the observation
area. See Fig. 4.
1 Night Vision
.3
The camera has eight high-intensity LEDs for picking up clear images in the
dark. When the light sensor detects low ambient light levels, the LEDs will be
automatically activated.
1 Pairing
.4
The system comes with a camera unit that has already been paired with the
monitor unit. The pairing function gives each camera unit a separate channel on
the monitor unit. This is necessary for configuring additional camera units.
1.
Press and hold power button over 3 seconds on camera. The power LED
will light up (red light) and night light will start blinking (orange light).
This will turn on the power of camera and camera will wait for pairing.
2. Press the Power button
will light up (green).
3.
In the submenu (8. Add Camera see Fig. 8.) on monitor.
4.
Please choose which number of cameras you want to add, and then press
the icon.
5.
Pairing is completed, it will show "
6.
Pairing is failed, it will show the picture on the monitor. See Fig. 17.
Note : Make sure the camera and the monitor are within range of each other.
LCD screen and the warning sound will be emitted from the monitor
unit if the monitor exceeds the range (unlink). The warning sound will
be emitted from the monitor until you press any button to stop.
2
camera.
See Fig. 15.
If there is out of range, the picture (Fig. 17.) will be displayed on the
to turn on the monitor and the power LED
" on the monitor.