Line Output - Teac NT-505 Manual Del Usuario

DSD digital filter
This sets the type of digital filter used when converting DSD signals
from digital to analog.
MENU
DIGITAL FILTER(DSD)
WIDE
NARROW
The cutoff frequency will be set according to the DSD signal as
follows.
DSD signal
2.8 MHz
5.6 MHz
11.2 MHz
22.5 MHz
WIDE
The cutoff frequency will be set according to the DSD signal as
follows.
DSD signal
2.8 MHz
5.6 MHz
11.2 MHz
22.5 MHz
Clock sync
o Clock sync is only possible when the input source is USB or NET
(including USB flash drives).
MENU
CLOCK SYNC
OFF
OFF
No clock sync is used.
ON
This unit's master clock will be synchronized to the 10MHz clock
input through the CLCOK SYNC input (10MHz IN) connector.
Cutoff frequency
39 kHz
78 kHz
156 kHz
312 kHz
Cutoff frequency
76 kHz
152 kHz
304 kHz
608 kHz

Line output

Use to select the connectors that output analog audio.
o Output through both the RCA connectors and the XLR connec-
tors at the same time is not possible.
MENU
LINE OUT SELECT
RCA
RCA
Output through the RCA connectors.
XLR (HOT 2)
Output through the XLR connectors with 2: HOT polarity.
XLR (HOT 3)
Output through the XLR connectors with 3: HOT polarity.
Line output level
Use to select audio level output from the analog audio output (LINE
OUT) connectors.
MENU
LINE OUT LEVEL
FIXED 0dB
FIXED 0dB
A maximum of 2 Vrms is output. Select this if you want to adjust
the volume using an amplifier.
o No sound will be output if headphones are connected.
FIXED +6dB
A maximum of 4 Vrms is output. Select this if you want to adjust
the volume using an amplifier.
o No sound will be output if headphones are connected.
o If the sound distorts, set this to FIXED 0dB.
VARIABLE
This will enable adjustment of the analog output level using the
VOLUME knob. Select this if you want to adjust the volume using
this unit.
o No sound will be output if headphones are connected.
OFF
No sound is ever output.
EN
23