Painting The Frame And Front Grille - Ecler IW6PLUS Manual De Instrucciones

The procedure for installing each unit is described below:
1. Use the template supplied to mark the perimeter of the hole to be made on the installation
surface.
2. Make the hole and pass the end of the cable to be connected to the speaker through it.
3. Insert the plastic frame into the hole, taking care to ensure that the 6 rotating tabs are in a
tangential position with respect to the cut.
4. Tighten each of the 6 screws that can be accessed from the front of the frame. The tabs
will rotate 90º and after tightening, the frame will be fixed in its final position.
5. Connect the end of the peeled cable to the spring clamp terminals located at the back of
the unit. Always respect the polarity of all the units with respect to each other and with
respect to the amplifier to which they are connected.
6. Insert the speaker into the frame. Insert and tighten the 6 screws to fix the speaker to the
frame
7. If required, move the treble transducer by pressing gently on the edge of the part
containing it, trying to aim it at the foreseen listening point. Take care not to force the
device beyond its mechanical limits (±15° in any direction) and do not touch the treble
transducer dome, as this could cause permanent damage to it and affect the reproduction
quality.
8. Install the protective front grille by applying pressure gently and evenly to the edges.

6. PAINTING THE FRAME AND FRONT GRILLE

Both the plastic frame and grid at the front can be painted, to adapt the unit to the aesthetic
criteria based on which it is to be used.
Dismantle the frame-speaker-grid unit completely and paint these two parts separately.
Pay special attention to ensure that the tiny holes in the front grid are not blocked. Use the
appropriate air drying paint.
When the paint is dry, install the unit in accordance with the steps described in section "5.
LOCATION AND ASSEMBLY".
6