Nintendo Wii Zapper Manual De Operaciones página 2

Configuration 1: Zapper – Nunchuk Attached
NOTE: If your Wii Remote has the Wii Remote Jacket, remove it before attaching the remote to the
Wii Zapper. Replace the jacket when you remove the remote from the Wii Zapper.
1. Remove the cable storage cover by pressing and sliding it
towards the bottom of the Wii Zapper.
2. Open the Nunchuk lock. Place the Nunchuk into the
compartment, aligning the projections with the screw
holes on the underside of the Nunchuk.
Close the Nunchuk lock over the base of the Nunchuk.
3. Feed the cable along the underside of the Wii Zapper,
pressing it into the slot.
Wrap the cable around the projections inside the
compartment 3-1/2 times, leaving some extra cable to
connect to the remote.
4
Configuration 2: Zapper – Nunchuk Separate
NOTE: If your Wii Remote has the Wii Remote Jacket, remove it before attaching the remote to the
Wii Zapper. Replace the jacket when you remove the remote from the Wii Zapper.
1. Thread the wrist strap cord through the connector hook
on the bottom of the connector plug.
Insert the plug into the External Extension Connector on
the bottom of the Wii Remote.
2. Place the remote into the compartment, front end first,
while pressing the Wii Remote lock release.
Let go of the lock release when the remote is fully
inserted into the compartment. The tabs on the lock
should be inserted into the two holes on the bottom of
the remote.
Make sure that the
Wii Remote is securely
locked in place.
IMPORTANT: Wear the wrist strap and tighten the strap lock for this configuration. Review the Wii
Operations Manual - System Setup for more information on wrist strap usage.
6
4. Replace the cable storage cover, feeding the cable through
the slot at the top of the compartment.
5. Thread the wrist strap cord through the connector hook
on the bottom of the connector plug.
Insert the plug into the External Extension Connector on
the bottom of the Wii Remote.
Screw
holes
6. Place the remote into the compartment, front end first,
while pressing the Wii Remote lock release.
Let go of the lock release when the remote is fully
inserted into the compartment. The tabs on the lock
should be inserted into the two holes on the bottom of
the remote.
NOTE: Extra cable can be tucked back into the cable
storage compartment.
Make sure that the
Wii Remote is securely
locked in place.
Removing the Wii Remote and Nunchuk
1. Press and hold the Wii Remote lock release and remove
the Wii Remote from the compartment, bottom end first.
Unplug the connector from the bottom of the remote and
remove the wrist strap cord from the connector hook.
2. Remove the cable storage cover by pressing and sliding it
towards the bottom of the Wii Zapper.
Unwind and remove the cable and replace the cover.
3. Open the Nunchuk lock and remove the Nunchuk from the
compartment.
Press
Replace the Nunchuk lock.
Press
5
Press
7