Brigmton BSK 651 Manual De Instrucciones página 12

IMPORTANT
The use of adults or minors (12 years and older) ALWAYS under the
supervision of an adult is recommended. Not recommended for children
under 12 years.
A learning process is required for the use of this device. Just as the learning
process to drive a bicycle or a motorcycle requires practice, the use of the
electric scooter needs practice before making any moves, turns or raising
the speed. Using it without a proper learning process can lead to injury.
It should be noted that the speed achieved can vary depending on the
weight of the driver, type of ground, temperature, driving style, etc.
ALWAYS wear protections such as helmet, knee pads, elbow pads and
protective gloves.
- We do not recommend using the device on public roads.
- Do not use the device on rainy days, in addition to the risk of water
damage to electronic equipment.
- Check the legal regulations on the use of these devices in your country.
Our company can not be held responsible for an improper use of the
device. We recommend that you carry out the learning process before using
the device.
The skate can only transport one person.
MAINTENANCE INSTRUCTIONS
CLEANING
To clean the skate, use a damp cloth. If you need to scrape dirt, use a soft
stiff brush and then a damp cloth. In case the dirt is very sticky you can use
a little toothpaste. Remember to wipe with a damp cloth after this.
Be sure to keep the skid off while cleaning and make sure you cover the
load inlet to avoid problems with the electronic components.
Do not use alcohol, gasoline, kerosene or other volatile or corrosive
chemical components. This can damage both the appearance and the
internal structure of the scooter. Also, do not use a pressure water gun or
running water.
CONSERVATION
Store the scooter in a cool, dry environment when not in use. Avoid leaving
it outside, as it is not manufactured for use in wet areas. It is also not
recommended to expose it to high temperatures caused by direct sunlight
for a long time.
BATTERY MAINTENANCE
Do not exceed the permitted operating temperature, above or below, for a