Brigmton BSPORT-BB Manual De Instrucciones página 9

INTRODUCTION
The sensor should be in contact with the skin when measurements are
taken. Always keep the sensor part clean.
Adjust the bracelet as indicated:
Charging the battery: Make sure the bracelet has enough battery the first
time you use it. If you can not turn it on, charge the bracelet
To charge, remove the body of the bracelet and connect it to a USB port.
On / off: While off, press and hold the function area for 4 seconds to start
the device with vibration.
On: On the power off page, press and hold the function key for more than
3 seconds to enter the power-off interface, and with a short touch to select
power OFF, the system will turn off if no operation is performed within 3
seconds.
1) In the on status, briefly touch the function key to illuminate the screen
to the default page with date and time information.
2) On the default date / time page, briefly touch the function key to change
the band to different pages. The screen will turn off if no operation is
performed in 5 second.
3) On the heart rate / blood pressure page, long press the function key to
start the measurement. The result will be displayed in 50 s, and then the
screen will automatically turn off.
System requirements: Android 5.0 and higher; iOS9.0 and higher; Support
Bluetooth 4.0.
Charge the battery completely before first use. Take out the center part of
the bracelet and connect to a USB socket.