Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OWNER'SRESPONSiBiLiTIES
Follow the hourly or calendar intervals, whichever occurs first.
More frequent service is required when operating in adverse conditions noted below.
MABNTENANCE SCHEBULE
_ABNTENANCE TASK
PRESSURE WASHER
Chec_dcieanwater inlet screen
Check high pressure hose
Check detergent hose
Check spray gun for leaks
Purge pump of air and contaminants
Prepare pump for storage below 32°F
ENGINE
Before
Each Use
X 1
X
X
X
X
OPERATINGINTERVALS
Every 25
1 Evely 50
Hours or
Hours or
Yearly
Yearly
See WiRter Storage,
Every lO0
Hours or
Yearly
SERVICEDATES
FILL IN DATESAS YOU COMPLETE
REGULARSERVICE
Check oil level
Clean debris
Change engine oil
Service air cleaner
Service spark plug
Service spark attester
Clean cooling system
Prepare for storage
X
X
X
X
X_
If unit is to remain idle for longer than 30 days,
Clean if clogged. Replace if perforated or torn.
Change oil after the first (5) operating hours and every 50 hours or yearly thereafter. Changesooner when operating under dirty or dusty conditions.
Replace more often under dirty or dusty conditions,
GENERALRECOMMENDATIONS
Reguiar maintenancewill improve the performance and
extend the life of the pressure washer. Seeany Sears or
other qualified service deaier for service.
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence. To
receivefuli value from the warranty, the operator must
maintain pressure washer as instructed in this manual
including proper storage as detaiied in Storage.
Some adjustments wili need to be made periodicaliy to
properiy maintain your pressure washer.
Ali service and adjustments should be made at ieast once
each season. Foiiow the requirements in the Maintenance
Schedu/echart above.
NOTE:Oncea year you should clean or replace the spark
ptug and repiace the air fiiter. A new spark piug and clean air
fiiter assure proper fuel-air mixture and hetp your engine run
better and iast longer.
EMiSSiONCONTROL
Maintenance, replacementor repair of the emission control
devices and systems may be performed by any non-road
engine repair establishment or individual.
BEFOREEACHUSE
1.
Checkengine oil Ievei.
2.
Cleandebris.
3.
Checkwater inlet screen for damage.
4.
Checkhigh pressure hose for ieaks.
5.
Checkcleaning tank for damage.
6.
Checkspray gun for ieaks.
7.
Purge pump of air and contaminants.
PRESSURE W ASHER MAINTENANCE
Cmean Debris
Daily or before use, clean accumuiated debris from cleaning
system. Keep linkage, spring and controts ctean. Keep area
around and behind muffler free from any combustible debris.
Inspect cooiing air siots and openings on the pressure
washer. These openings must be kept clean and
unobstructed.
Cleaningsystem parts should be kept clean to reduce the risk
of overheating and ignition of accumuiated debris.
o
Use a damp cloth to wipe exterior surfaces clean.
,
Use a soft bdstie brush to loosen caked on dirt, oil, etc.
15
Publicidad
Tabla de contenido
