Unitekno C102 Manual De Uso página 10

WARNING!
Do not use this machine if there are
signs of damage (cracks, breaks),
if the power cord is damaged, or if
you suspect that there may be an
internal defect (for example, after the
machine has fallen).
If the power cord is damaged, a
manufacturer-authorised service
centre must replace it since a special
tool is needed to access it.
Read the rating-plate located under
the machine; make sure the voltage
and input ratings comply with the
system's capacity.
Plug the machine into a grounded
outlet.
While moving the machine, avoid
tugging on the power cord.
Disconnect the machine from the
electrical power source by pulling the
plug. Do not disconnect it by pulling
on the cord, since this could damage
the machine.
8
Do not leave the machine unatten-
ded while it is plugged in.
Do not let children or other incom-
petent persons use the machine.
Do not attach devices that exceed
the indicated input rating to the
machine!
Only use the machine's original
accessories, which are guaranteed
compatible by the manufacturer.
This machine has been manufac-
tured for use in enclosed (covered)
areas.
Do not submerge the machine in
water!
Do not open the boiler valve cap
while under pressure.
Do not point the steam jet
at persons or other living
beings. This machine pro-
duces high-temperature
steam. Avoid direct contact with
the skin.
ATTENTION! Danger of burning. Va-
por must never be directed toward
equipment containing electrical
parts, like the inside of ovens.
Before switching on the appliance,
check that valve cap (V) is lowered
as in the diagram.
Do not place any type of substance
(detergents or anything else) in the
boiler if not specifically approved by
the manufacturer.
Before using the machine to clean
surfaces that may get damaged
(e.g. synthetic fibres, plastics,
wood, etc.), check their capacity
to withstand high temperatures by
doing a trial run on a hidden area
and by carefully following manufac-
turer's instructions.
Only use original replacement parts
for any necessary repairs. Please
see an authorised service centre.
Disconnect the equipment from the
electrical system before proceeding
with cleaning or maintenance
operations.
The filling aperture must not be
open during use.