Briggs & Stratton Snapper SST-16CL Manual Del Propietário página 5

•
TOOL LIST
• Screwdriver (Phillips or Standard)
• Allen wrench 4ram
• 10ram wrench
\
INSTALLING DEBRIS GUARD
Put the debris guard on the gear box, attach it with the
screw and nut provided.
• INSTALLING CUTTING HEAD
• While locking the gear shaft by inserting a pin into the
upper holder and the housing.
• Rotate the cutting head to clockwise to engage threads.
Hand-tighten it securely.
• STOP AND START SWITCH
1. Ignition switch
2. Stop
3. Start
INSTALL ASSIST HANDLE
Use the 3 screws provided for this assembly. Mount the back
edge of the handle clamp to match the arrow on the tube.
Adjust the handle for comfort and good balance. Check that
the cutting line of the unit is away from your feet and legs.