Care And Maintenance - Black and Decker BDC204-LA Manual De Instrucciones

CARE AND MAINTENANCE

The Black & Decker® Thermo-Electric Travel Cooler & Warmer
ruggedly constructed to provide years of dependable service.
• After each use, clean the unit, inside and out, with a soft cloth and mild
soap solution.
• Do not scrape, scratch or puncture the surface of the cooler with sharp objects
or abrasives.
• Dry the unit properly and store in a cool, dry place.
• Always make sure the power cord is disconnected before storing.
• Never allow the cooler/warmer to be immersed in liquid.
TROUBLESHOOTING
Problem/Possible Cause/Remedy
• Travel Cooler/Warmer is not functioning as cooler or warmer
(fan is not turning).
Accessory outlet of DC power supply is not functioning – check by plugging
in a 12 volt DC appliance. If not, clean accessory outlet and re-connect the
Black & Decker® Thermo-Electric Travel Cooler & Warmer.
• Fuse or circuit breaker in accessory outlet is open. Reset breaker or check fuse,
and replace fuse if necessary.
• Ignition is switched off – start engine or switch ignition to "accessory" position.
• Fuse in unit's power plug is blown – see Fuse Replacement section for location of
fuse and instructions for checking and replacing fuse.
• Cooler/warmer is not cooling or heating properly (fan is not turning).
Fan is defective. Call your service center for return/ replacement instructions. This
unit is not user-serviceable, it must be returned to manufacturer for professional
service or repair. Any attempt to service by user will void warranty.
• Cooler/warmer is not cooling or heating, but fan is turning.
Cooling unit is defective. Call your service center for return/replacement
instructions. This unit is not user-serviceable, it must
manufacturer for professional service or repair. Any attempt to service by user
will void warranty.
• Travel Cooler/Warmer takes longer than 2 hours to reach desired
temperature inside
– Low battery or supply voltage.
– Unit will attain desired temperature more efficiently if items are pre-heated
or pre-chilled.
– Fan area is blocked – move unit or object.
be returned to
27
SPECIFICATIONS
is Capacity:
Power Supply:
Power Cord:
Amperage Draw:
Cooling Performance:
Warming Performance: Warms to 48.8°C (120°F)
High Temperature Limit: Automatic ON/OFF
Cold/Heat Transfer:
Insulation:
Heat Dissipation:
Warm/Cool System:
6 liter / 8 can / 1.5 gallons (US) capacity
12 volt DC
7' with 12 volt DC accessory plug and 5 amp fuse
3 amps (approx. 36 watts)
Cools down to as much as 22.2°C (40°F) below
surrounding air
Temperature-efficient, aluminum-coated liner
CFC-free polyurethane liner
Built-in fan with long-life, brushless motor
Non-wearing thermoelectric
28