Cleaning And Maintenance - Active Era LUXURY CAMPING AIR BED Manual De Instrucciones

Two Stage Valve
1. To deflate the air bed, open the second stage of the two stage air valve
to fully open the air valve.
2. From the end of the air bed opposite the two stage valve slowly fold up
or roll the air bed up in the direction of the two stage valve thereby
forcing the air out of it.
3. Once fully deflated close the the second stage of the two stage air
valve.
4. The air bed is now ready to pack away.

CLEANING AND MAINTENANCE

1. Use soapy water to clean the surface of the air bed. Do not use
chemicals.
2. No air pump maintenance is required.
3. To repair punctures to the air bed, use the provided puncture repair
patches.
WARNING: Always ensure that the air pump is switched OFF and that the
USB charging cable is unplugged from the electrical outlet before cleaning
or performing maintenance procedures.
CAUTION: Do not allow water or other liquids to run into the interior of the
rechargeable air pump, as this could create a fire and/or electrical hazard.
Do not use any abrasive cleaners or solvents, as this will damage the
appliance.
STORAGE
1. Choose a flat surface large enough to accommodate the inflated air
bed.
2. Remove any sharp or pointed objects on or near the surface.
3. Lay the air bed out with the flocked surface touching the floor.
4. Remove the screw cap and rubber bung from the top of the integrated
foot pump and place safely to once side.
5. Standing with your foot on top of the integrated foot pump press down
and lift up in a repeating motion to inflate the air bed to the desired
English | 6