Safety Instructions; Important - ALFRA TMA 600A Manual De Instrucciones

Dear customer,
Thank you for purchasing an ALFRA product. Please read these operation instructions closely before using your
device for the first time and keep them along with the enclosed Product Control Card for later reference.

Safety instructions

Danger can occur when using extremely strong magnetic clamps due to improper handling and/or poor
maintenance, which may cause serious accidents with fatal physical injuries. Please observe all safety instructions
of this operation manual and contact the manufacturer if you have any questions.

Important:







.
Always...










Never...













People using pacemakers or other medical devices should not use this magnetic clamp until
they have consulted with their physician.
10
stability and safe hold do not occur on round or arched surfaces
use the magnetic clamp preferably on plane surfaces
full performance is only reached when using the entire magnetic surface
cavities or drilled holes underneath the surface reduce the magnetic holding force
fixing several work pieces on top of each other decreases the holding force significantly
ensure that the lever springs back strongly during work on thin materials
activatethemagnetic clamp completely
activate the magnetic clamp on metallic, ferromagnetic materials
clean the magnetic surface and keep it clear of dirt, chips and welding spatter
set the magnet clamp down gently to prevent damage to the magnetic surface
respect the stated maximum breakaway force
inspect the magnetic surface and the entire magnetic clamp for damage
follow the instructions in this operating manual
instruct new operators in the safe use of switchable magnetic clamps
respect local and country-specificguidelines on handling magnetic tools
keep and use in a dry environment
exceed the stated maximum load
use the magnet to position objects above people or walking paths without using additional
safeguards
use the magnetic clamp to lift or transport loads
use the magnetic clamp to support, lift or transport persons
switch the magnetic clamp off before setting down all work pieces in a safe end position
modify the magnetic clamp or remove operating labels
use the magnetic clamp if damaged or missing parts
strain the underside of the magnet through heavy impact or blows
use the magnetic clamp without having been properly instructed
use if you have not read and understood these operating instructions completely
place fingers or any other body part between the magnetic surface and the work piece
because there is a risk of injury
operate in temperatures higher than 60°C (140°F)
expose to corrosive substances
10