Door Reverse - HAEGER 90D&E RE-90W.024A Manual De Instrucciones

English

Door Reverse

This refrigerator has been built with the door hinges on the right or on the left dependent of
the model. If you want to change the opening direction, please follow the instruction below.
WARNING: When reversing the door, the appliance must not be connected to the mains.
Remove the plug from the mains beforehand.
1. Remove the protective cap (1) from the hinge.
2. Remove the screws (2) from the upper hinge. Remove the hinge (3).
3. Remove the door protective small cap at the top, and place it in the hole at the opposite
side. Remove the door (8) and place it on a surface that will not scratch it.
4. Lie down the unit on the floor for support and remove the adjustable feet (4 & 7).
5. Unscrew the screws (6) of the bottom hinge (5) and fix it on the opposite side of the
appliance. Replace the adjustable feet (4 & 7).
6. Reposition the unit on it original position and hang the door on the appliance.
7. Finally, screw the upper hinge back in place. Make sure the rubber gasket seals tightly.
Position the door so that it lines up above the appliance. Tighten all screws and place the
protective cap (1).
8