Sears CRAFTSMAN 917.28924 Manual Del Operador página 75

Tabla de contenido

Publicidad

The operation of any tractor
can result
in foreign
objects
thrown
into
the eyes, which can result in severe eye damage.
Always wear safety
glasses or eye shields while operating your tractor
or performing
any
adjustments
or repairs.
We recommend
standard safety glasses or a
wide vision safety mask worn over spectacles.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your
tractor
is equipped
with
an operator
presence
sensing
switch.
When
engine
is
running,
any attempt
bythe
operator
to leave
the seat without first setting the parking
brake
will shut off the engine.
1.
Depress
clutch/brake
pedal
(B) all the
way down
and hold.
2.
Pull parking
brake lever (C) up and hold,
release
pressure
from clutch/brake
pedal
(B), then release
parking brake lever. Ped-
al should remain in brake position.
Ensure
parking
brake
will hold
tractor
secure.
• Move
motion
control
lever
(J) to neutral
position.
ENGINE
-
• Movethrottle
control
(D) between
half and
full speed
(fast) position.
NOTE:
Failure
to move throttle
control
be-
tween
half and full speed
(fast) position,
be-
fore stopping,
maycause
engineto
"backfire".
STOPPING
MOWER
BLADES
-
• To stop mower
blades,
move
attachment
clutch
clutch
lever to disengaged
position
(t_
a)Attachment
(t'_)
Disengaged
Clutch
Position
Engage Position
GROUND
DRIVE-
. To stop ground
drive, depress
clutch/brake
pedal
(B) all the way down.
• Turn
ignition
key (F) to "STOP"
position
and remove
key. Always
remove
key when
leaving tractorto
prevent unauthorized
use.
IMPORTANT:
Leaving
the ignition
switch in
any position
other
than
"STOP"
will cause
the battery
to discharge
and go dead.
NOTE:
Under certain conditions
when tractor
is standing
idle with the engine
running,
hot
engine
exhaust
gases
may cause
"brown-
ing" of grass.
To eliminate
this possibility,
always
stop
engine
when
stopping
tractor
on grass
areas.
CAUTION:
Always
stop tractor
com-
pletely,
as described
above,
and set parking
brake before
leaving
the operator's
position.
TO USE THROTTLE
CONTROL
(D)
Always operate engine at full speed (fast).
• Operating
engine at less than full speed
(fast) reduces engine's operating efficiency.
• Full speed
(fast) offers the best mower
performance.
11

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido