Kreg KPCS Manual Del Propietário página 3

1 Remove the Drill Guide Block from the drill-guide socket of your
Kreg K3, K4, or K5 pocket-hole jig.
®
2 Slide the Plug Cutter guide block into the drill-guide socket, seating
it all the way at the bottom. Secure the guide with the locking pin.
3 Slide the stop collar onto the Plug Cutting Bit until it rests on the
bit shoulder. Tighten the stop-collar set screw with the hex wrench.
Chuck the bit into your electric drill.
ATTENTION
1300 rpm to 2500 rpm. To obtain good quality plugs from a
lower rpm drill, slow the feed rate. Higher rpm drills produce
good quality plugs at a faster feed rate, but produce more heat.
When using a high rpm drill, pace your production rate to allow
time for the bit to cool.
Stop Collar
Electric drills commonly run at speeds from
Setup
Shoulder