Princess 01.347000.01.001 Manual De Usuario página 7

Remote control buttons
• Cool mode: In cooling mode, the LED lamp is blue. Press this
button to activate the cooling mode. Note: The default start mode
is the cooling mode.
• Heat mode: The display number in heat mode is orange. Press
this button to activate the heat mode.
• Oscillation button: Press the Oscillation button to turn on the
oscillation function. The fan will swing from left to right. Press this
button again to stop oscillating.
• Power button: The device can be switched on and off by pressing
the power button.
• Increase/Decrease volume of air: Press the "+" button on the left
side of the remote control to increase the volume of air, press the
"-" button on the left side of the remote control to decrease the
airflow. It can be set in 1-10 fan speed in cooling mode, heat
mode can be set for 4 levels.
• Natural mode: The device show the current fan speed on screen,
the fan simulates the natural breeze, it works in both cooling and
heating mode.
• Timer: Press the timer button to select the desired range between
1 hour to 24 hours.
• Sleep mode: Sleep mode works in both heating and cooling. The
fan speed will reduce to speed 1 from whichever fan speed you
set. The display will show the current fan speed where it reduced
to.
• Increase/Decrease temperature: In heat mode, press the
temperature button on the right side of the remote control to set
the temperature between 16°C and 30°C. Note: this button does
not work in cool mode.
• Mute: This will turn off the sounds of the device.
Heating mode instructions
• Press the heat mode button and the display shows the ambient
temperature.
• Press temperature button to set the temperature, the display will
flash digitally, which can be set to 16 to 30 degrees.
• Set temperature should be higher than the ambient temperature,
so that the heating function will be turned on.
• When the ambient temperature reaches the target temperature,
the heating element will stop for a while and machine will be
fanning to vent heat, after a few seconds the fan will stop too until
the ambient temperature is below target temperature.
• If the ambient temperature is lower than the set temperature the
heating function will activate automatically.
• Note: The default setting temperature is 20 °C. In the heat mode,
when the ambient temperature is below 0 °C, the display only
shows 01, it does not display negative temperature value. When
the heat mode runs over 9 hours, the machine will automatically
stop. Restart by pressing the host power button or by using the
button on the remote control.
Instruction manual
EN
7