Poulan PLB 26 Manual De Instrucciones página 4

a WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all
fasteners are secure. Follow all safety information in the manual and on the unit.
NOTE: It is normal for the fuel filter to rattle in the empty fuel tank.
KNOW YOUR BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the
illustrations with your unit to familiarize yourself with locations of the various controls and adjustments. Save this manual
for future reference.
B
C
F
E
BEFORE STARTING ENGINE
a WARNING: Be sure to read the fuel information
in the safety rules before you begin. If you do not
understand the safety rules, do not attempt to fuel
your unit. Call 1-800-487-5951.
MIXING FUEL
To obtain the correct oil mix ratio, pour 2.6 ounces of
2-cycle synthetic oil into one gallon of fresh gas.
IMPORTANT: This equipment is designed to operate on
unleaded gasoline with a minimum 87 octane (R+M/2
method), with ethanol blended up to 10% maximum by
volume (E-10). Before operation, gasoline must be mixed
with a good quality synthetic 2-cycle air-cooled engine oil
designed to be mixed at a ratio of 50:1.
Mix gasoline and oil at a ratio of 50:1. A 50:1 ratio is
obtained by mixing 2.6 fluid ounces of oil with 1 gallon of
unleaded gasoline. DO NOT USE automotive oil or marine
oil. These oils will cause engine damage. When mixing fuel,
follow instructions printed on container. Once oil is added
to gasoline, shake container momentarily to assure that the
fuel is thoroughly mixed. Always read and follow the safety
rules relating to fuel before fueling your unit. Purchase fuel
in quantities that can be used within 30 days to assure fuel
freshness.
A
J
D
H
G
ASSEMBLY
OPERATION
A. Stop switch
B. Throttle trigger
C. Air filter cover
D. Starter rope handle
E. Fuel tank
F. Choke lever
G. Fuel cap
H Fuel primer bulb
J. Idle speed adjustment screw
CAUTION: Never use straight gasoline in your unit. This
will cause permanent engine damage and void the limited
warranty. Do not use alternate fuels such as ethanol blends
above 10% by volume (E-15, E-85) or any methanol
blended fuel.
Use of these fuels can cause major engine performance
and durability problems.
FUELING YOUR ENGINE
• Remove the fuel cap and pour mixed fule into the fuel
tank. Replace fuel cap tightly.
• Move at least 3 meters (10 feet) away from the fueling
site.
• Place the machine on the ground, and hold the machine
handle firmly with your right hand. Make sure the blower
end is directed away from people, animals, glass, and
solid objects.