Publicidad
Idiomas disponibles
Idiomas disponibles
valve seat replace valve.
3.- IF JACK WILL NOT LOWER COMPLETELY
WHEN RAISED
a) Return spring for lifting arm may be broken
or unhooked replace return spring.
b) It probably needs lubrication. Clean and oil
all moving parts in the lifting arm mechanism.
c)
Hydraulic unit may contain too much oil
and vent valve may be closed. Open vent plug.
4.- If Jack Will Not Lift Full 1.5 tons Capacity.
CHECK THE FOLLOWING:
a)
The O - ring seal for piston pump may be
worn. See instructions 1-c.
b)
The unit may have air trapped in the sys-
tem. See instructions 1-b
c)
The overload valve is factory adjusted for
the jack to lift 1.5 tons load should not be al-
SPECIFICATIONS
MAX HEIGHT
MIN HEIGHT
(cm)
A
30
HEIGHT
(cm)
(mm)
B
C
13
20
E N G L I S H •
tered. Examine jack for finding causing loss of
load.
WARNING
This is lifting device only: load must be suppor-
ted by proper rated capacity jack stands under
the vehicle before stanting inspection or work.
Do not overload-jack capacity is 1.5 tons.
Overloading can cause damage to jack and/or
failure resulting in personal injury or property
damage: this jack is designed for use on hard
level surfaces use on other than hard surfaces
can result in jack instability and possible loss
of load.
WIDTH
WIDTH
LENGTH
(mm)
(mm)
(cm)
F
G
135
201
43,8
U ser's man ual
LENGTH
OIL CAPACITY
(cm)
(oz)
D
D2
82
2
5
Publicidad
