Connection Diagram; Installation - KPS CONFORTLINE TERMODIGI Manual De Usuario

4 AdJ
5 FrE
6 LOC
7 FAC

Connection diagram

Installation

1. After open upper panel and bottom panel, fix the bottom panel on the wall using two screws,
entering the required wires through hole of the bottom panel. It is recommended that the wires
have a length of 20 cm in order to facilitate the connection.
2. Install two AA batteries and connect the wires on input terminals.
3. Finally, close bottom panel and upper panel.
Room
temperature
adjust
(Calibration)
Anti-freezing
function
Lock function
Factory default
-5ºc – 5ºC
00: Anti-freezing function shutdown
01: Anti-freezing function enabled
00: Lock disabled
01: Half lock
02: Full lock
08: Maintaining current settings
00: Restore Factory default
NC: Normally close contact
COM: Common terminal
NO: Normally open contact
11
3. 0.0ºC
00
00
08