Amplicomms TV 2400 Manual De Instrucciones página 14

O
PERATION
Troubleshooting
No sound
- Ensure that the mains adapter is pushed fully into the power outlet and
that its cable is properly connected to the DC IN connector on the trans-
mitter.
- Ensure that the headset receiver power ON/OFF switch is switched to ON.
- The charge level of the battery inside headset receiver may be too low.
Recharge the battery or replace it with a fully charged battery.
- Ensure that the TV set, Hi-Fi system or audio component is switched ON
and set to a channel that broadcasts an audio signal.
- Use the volume control on the headset receiver to increase the sound
level.
- The connected audio/video equipment may not be in playback mode.
Start playback on by the equipment.
- The headset receiver output level is set too low. Adjust the volume to a
suitable level.
Distortion
- The charge level of the battery inside the headset receiver may be too
low. Recharge the battery or replace them with a fully charged battery.
- The headset receiver may be too far away from the transmitter. Move clo-
ser to it.
- The audio signal input level is too low. Increase the volume from the
audio source.
10
Helpline UK 0844 800 6503
(See page 32 for costs and hours of operation)