Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USE SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
The exclamation point with an equilateral triangle is intended to
！
alert the user of the presence of important operating and
maintenance (servicing) instruction in the literature accompanying
the appliance.
The lightning flash with arrowhead symbol, within an equilateral, is
intended to alert the user of the presence of uninsulated "dangerou
voltage" within the product's enclosure;that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
Introduction to MOD-ILL-ILL1U/1V (UHF/VHF PLL MODULATOR)
With UHF & VHF PLL modulator you will be able to distribute the signal
from any audiovisual equipment (satellite receivers, VCR etc) to all the TV-sets
of the house. Both modulators are especially useful for digital satellite
receivers without internal modulator and in general for distributing any signal to
UHF/VHF channel. Then you will be able to insert the signal in the side of the
installation without any appreciable attenuation in cables.
！
OPEN
1e
For the correct installation of the modulator watch very carefully the
location of the different connectors and the channel table. In order to choose
the output channel, locate by means of your TV-set, a free RF channel at your
antenna installation. We recommend choosing UHF/VHF channel (according
to model), in order to minimize the attenuation in the cables. Now switch to ON
the switches indicated at the channel table for the chosen channel. Keep
switch 1 at the OFF position in order to provide the test signal.
Carry out the video and audio connections from your audiovisual
equipment to the modulator. For the signal insertion to your antenna
installation, you can make the connections of fig1a/1b, installing a new cable
between the modulator and the head of the TV-set installation (then you can
combine both signals by means of a mixer) or carry out the assembly of the
figure 1c (if your equipments are located at the first TV-socket of the
installation).
At this moment you can connect the modulator to 240V or 230V or 220V
and tune all the TV-sets to the chosen output channel (the test signal will
appear). In order to eliminate the test signal SW1 to On. Once the electric
assembly is concluded you can mount the device on the wall.
Cautions:
In case of high output channels or in big installations, it could be necessary
●
the use of an amplifier before the antenna signal mixer.
In case of problems read the instructions again and check the connections in
●
your installation. In case of doubt or persistence of any problem ask your
distributor.
2e
Publicidad
