Using The Timer Function - Hitachi UR 18DSL2 Manual De Instrucciones

For Better Reception
NOTE
Disconnect the smartphone or cell phone except
when charging.
Do not make or receive calls on the smartphone
or cell phone in the vicinity of the radio as radio
reception may be adversely aff ected.
FM (Fig. 6)
Adjust the direction and angle of the antenna to
ensure the best reception.
When tuned in to an FM stereo broadcast, STEREO
is displayed.
If a lot of noise occurs during an FM stereo broadcast,
press the FM mode / Alarm button.
The radio switches to monaural (the STEREO
indicator turns off ) to reduce the noise. To return to
stereo reception, press the FM mode / Alarm button
again.
AM (Fig. 7)
The radio has a built-in antenna. Turn the radio
around to fi nd the direction with the best reception.
Positioning
Reception may be poor when the radio is used inside
a vehicle or building. When inside a building, place
the radio near the window to ensure better reception.
Noise may occur if the radio is placed near an
appliance that generates noise. Move the radio away
from the source of the noise.
Auto Power Off
The radio turns off automatically after 8 hours.
FM antenna
Fig. 6
Fig. 7

USING THE TIMER FUNCTION

○ The radio turns on/off at the preset time
○ Use the radio as an alarm clock
Sleep Timer
Setting the sleep timer turns the radio off after the set
time has elapsed.
1. Pressing the sleep timer / clock button while
the power is turned on displays the SLEEP
indicator. The time (minutes) indicator changes in
order of [90→80→70→...→10→OFF] in 10-minute
units each time the button is pressed.
2. Press the button repeatedly until the desired time
is displayed.
3. The radio turns off when the set time has elapsed.
4. To cancel the timer, press the sleep timer / clock
button until the indicator is set to OFF.
The SLEEP indicator goes off and the sleep
timer is cancelled.
To check the remaining time
The SLEEP indicator is displayed when the sleep
timer has been set.
Press the sleep timer / clock button to check the
remaining time on the timer.
Buzzer Alarm / Radio Alarm
NOTE
○ The volume of the buzzer alarm cannot be
adjusted.
○ If the rechargeable battery is running low, the
radio alarm timer may not work.
Charge the battery before setting the timer or use
the AC adapter.
○ The radio alarm turns on in the station and at the
volume selected before the timer was set. Set the
volume and time to avoid creating a disturbance
when the radio turns on.
When the alarm time is set and the buzzer alarm is
selected, the buzzer sounds at the preset time.
When the radio alarm is selected, the radio turns on
in the selected radio station at the preset time.
1. Set the time with the radio turned off .
2. Press and hold the FM mode / alarm button for
more than 2 seconds to switch to alarm mode.
The ALARM indicator is displayed.
3. The "hour" indicator blinks. Turn the select dial
or press the search button to select the desired
"hour".
English
15