Tool Assembly - Milwaukee 5336-22 Manual Del Operador

To reduce the risk of injury, always unplug tool
before attaching or removing accessories or
making adjustments. Use only specifically recom-
mended accessories. Others may be hazardous.
Adjusting the Side Handle (Fig. 1)
Fig. 1
1. Loosen the side handle slightly by unscrewing it counterclockwise.
2. Rotate the side handle to the required angle.
3. Tighten the side handle securely.
To reduce the risk of injury, always use a side
handle when using this tool. Always brace and
hold securely.
The side handle can be used at the rear of the tool. Remove the handle
and install it in one of the positions provided on either side (1).
WARNING!
1
WARNING!

TOOL ASSEMBLY

Installing Bits and Chisels (Fig. 2)
Round Hex System
These hammers use hammer steel chisels with round hex shanks.
Fig. 2
1. Insert the chisel into the nose of the tool. Make sure that the notch in
the shank faces toward the bit lock.
2. To lock, push the bit lock to the right as shown.
3. To unlock, push the bit lock to the left as shown.
NOTE: Use caution when handling hot bits and chisels.
Chisel with round hex shank
page 5