Warnings And Precautions - Daewoo DBU-050 Manual De Instrucciones

WARNINGS AND PRECAUTIONS

This symbol, located on the back or bottom of the unit, is intended to alert to
the user to the presence of uninsulated "dangerous voltage" within the Product's
enclosure that may constitute a risk of electric shock to persons.
This symbol, located on the back or bottom of the unit, is intended to alert to
the user to the presence of of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
This product utilizes a Class 1 laser to read Compact Discs. This laser Compact
Disc Player is equipped with safety switches to avoid exposure when the CD door
is opened and the CD player's lid is damaged. Invisible laser radiation is present
when the CD player is open and the system's interlock has failed or has been
damaged. It is very important that you avoid direct exposure to the laser beam at
all times. Please do not attempt to damage or bypass the safety switches.
CAUTION: TO PREVENT ELECTRIC SHOCK, ENSURETO INSERT 2 PIN PLUG
CORRECTLY INTO THE MATCHING SOCKET OR ADAPTOR.
To reduce the risk of electric shock, do not remove cover (or back). There are no user-
serviceable parts inside. Please refer any service to qualifi ed service personnel.
WARNING: Changes or modifi cations to this unit not approved by the party
responsible for compliance could void the user's authority to operatic the
equipment.
WARNING: To prevent fi re or shock hazards, do not expose this unit to rain
or moisture.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace
only with the same orequivalent type.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh, etc) batteries.
NOTE: This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, and uses radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the turning the equipment
off andon, the user is encouraged to try to correct the interference by one or more
of the following measures: Re-position or relocate the receiving antenna, Increase
the separation between the equipment and receiver, Connect the equipment into an
outlet on a circuit diff erent form that to which the receiver is connected. Consult the
dealer or an experienced radio/TV technician for help.
EN
9