Basic Settings; Selecting The Trigger Signal; Selecting The Replay Mode; Setting The Clock Manually - Monacor PA-1120DMT Manual De Instrucciones

5 Basic Settings

5.1 Selecting the trigger signal

The type of trigger signal can be selected for
remote-controlled retrieval of an emergency mes-
sage via the amplifier [connection "E/M TRIGGER
INPUT" (19)] or via the terminals "EMERGENCY"
on the connection plate (17).
1) Switch on the amplifier or the basic unit.
2) Press the button MENU (10). The display (4) will
show:
Mode Set
Time
3) Press the button UP (12) or DN (11) repeatedly
EM Type
until appears on the lower line of the
display.
4) Press the button ENTER (6).
appear on the first line of the display; the lower
line will show the current trigger type setting.
5) Use the button UP or DN to select the trigger
type and then press the button ENTER to con-
firm:
Latch
The message will be repeated as
long as the trigger signal is available.
Pulse
The message will be repeated until
the button START/ STOP (14) is
pressed.
To stay with the current trigger type, cancel the
setting by means of the button MENU.
Note: The menu will automatically be exited if no button is
pressed for approx. 30 seconds.

5.2 Selecting the replay mode

The replay of messages stored on the six main
storage locations usually consists of two steps:
1. Selecting the message
2. Starting the (multiple) replay
This applies both to the replay via the buttons on
the insertion module (
(remote-controlled) replay via switching contacts
( chapter 6.2.2).
For immediate message replay, rearrange the
jumper PLAY MODE SELECTOR (21). Switch off
the unit prior to rearranging the jumper.
replay after the button START/ STOP (14) or
REPEAT/ STOP (13) was pressed
immediate (multiple) replay when the mes-
sage is selected by means of the buttons
M1 – M6 (15)
EM Type
will now
chapter 6.2.1) and to the

5.3 Setting the clock manually

The clock can be manually set if synchronisation of
the integrated clock via the wireless transmitter is
not possible or not desired.
1) Switch on the amplifier or the basic unit.
2) Press the button MENU (10). The display (4) will
show:
Mode Set
Time
3) Press the button ENTER (6).
now appear on the first line of the display; the
lower line will show the current weekday setting.
4) Use the button UP (12) or DN (11) to set the
weekday desired:
Mon
Monda
Tues
Tuesday
Wednes
Wednesday
Thurs
Thursday
Fri
Friday
Satur
Saturday
Sun
Sunday
5) Press the button ENTER.
appear on the first line of the display; the lower
Hour:"
line will show "
setting.
6) Use the button UP or DN to set the hour and
then press the button ENTER to confirm. The
lower display line will now show "
current minute setting.
7) Use the button UP or DN to set the minute and
then press the button ENTER to confirm. The
display will now show the weekday and the time
set.
When a time signal is received,
appear on the display and the clock will be syn-
chronised.

5.4 Increasing the output level

If required, the output level can be increased by
10 dB: Switch off the unit and then rearrange the
jumper J1 (18) from the position "low" to the posi-
tion "hi".
Week Set
will
Time Set
will
and the current hour
Min:"
and the
DCF77 ON
will
GB
17