Installing / Removing The Battery Pack; Battery Pack And Charger; Battery Charging - Crafstman 151-98837 Manual Del Usuario

ATTACH SAFETY GUARD
See Figure 5, page ii
■ Align the three pre-inserted screws in
the safety guard with the three holes in the
trimmer head.
■ Tighten the screws into the holes to secure
the guard to the head.
INSTALLING / REMOVING THE BATTERY
PACK
See Figure 5b, page ii
To install battery pack:
■ Align the groove on each side of the battery
pack with the edges of the terminal plate on
the underside of the forearm pad.
■ Grasp the trimmer firmly by the handle.
■ Slide the battery pack onto the terminal
plate until it secures into place.
■ Do not use force when inserting the battery
pack. It should slide into postion and "click".

BATTERY PACK AND CHARGER

BATTERY CHARGING

■ Use only with 60V Craftsman battery
chargers. The battery charger supplied is
specifically designed for the Lithium-Ion
battery used in this tool.
■ Check the power voltage! Battery chargers
operate on 120 V.
■ Charge the battery between 35.6°F and
109.4°F. This ensures an optimum battery
service life.
ASSEMBLY
NOTE: Make sure that battery pack firmly
snaps into place and is secured to the
trimmer handle before starting operation.
To remove battery pack:
■ Stop the trimmer by fully releasing trigger.
■ Insert finger tip beneath edge of battery
pack release button and press and hold
button up.
■ Slide battery pack off of terminal plate.
■ Protect the battery from heat, from
continuous exposure to sun and keep away
from radiation or other heat sources. Do not
leave the battery in the tool in direct sunlight
over long periods.
■ The battery is supplied uncharged. Fully
charge the battery before using the tool for
the first time. The Lithium-Ion battery can
be charged at any time without reducing
its service life. Interrupting the charging
procedure does not affect the battery.
9 ― English