ARCTIC DELUXE SERIES 1 TECHNICAL CHARACTERISTICS damage is found, call the delivering carrier immediately to file a claim. 3 Install the unit on a counter top that will support the combi- 20/1PD 20/2PD 20/3PD 20/4PD ned weight of dispenser and product bearing in mind what is stated in the preceding point 1 IMPORTANT warning.
9 This unit is not to be installed in areas subject to water- 5. 2 OPERATION HELPFUL HINTS spouts.. 10 Do not use water-jets to clean the unit. 1 The length of time for cooling down the product is governed 11 This unit can work in a room temperature range between by many variables, such as ambient temperature and beverage +5°...
Página 4
ARCTIC DELUXE SERIES 4 In the same manner clean the evaporator cylinder(s) using dispensing handle (see figure 2). a soft bristle brush. 5 Rinse all cleaned parts with cool clean water. 5. 3. 3 SANITIZING Sanitizing should be performed immediately prior to starting the machine.
figure 5 5 Use fresh product to chase any remaining sanitizer from the bowl(s). Drain this solution. Do not rinse out the machine. 5. 4 IN-PLACE SANITIZATION Daily: The In-Place Sanitization prior to starting the machine may be performed, if needed, only as further precaution, in addition to the Disassembled Parts Sanitization described before, but never in lieu of it.
ARCTIC DELUXE SERIES 2 Controlar que el distribuidor no haya sufrido daños durante 1 CARACTERISTICAS TECNICAS el transporte. De haberlos sufrido, reclamar inmediatamente al transportista. 3 Colocar el distribuidor en un mostrador en grado de 20/1PD 20/2PD 20/3PD 20/4PD sostener su peso incluso con la carga completa, teniendo en Contenedores transparentes desmontables cuenta cuanto indicado en IMPORTANTE, del punto 1.
11 Para el correcto funcionamiento, coma la temperatura Para el funcionamiento del distribuidor: 1 Colocar el interruptor general en posición I. ambiente debe estar comprendida ientre 5°C y 32°C (14F y 2 Colocar el interruptor agitación en posición I. 90F). 5 INSTRUCCIONES DE EMPLEO 5.
Página 8
ARCTIC DELUXE SERIES 3 Quitar la junta del contenedor. bebida. 4 Sacar la turbina pompa. ATTENCION 5 Grifo en acero inox por gravedad: Sacar el pisón y desmontar la palanca mando grifo (ver figura 2). Durante el lavado del distribuidor no usar mucha canti- dad de agua cerca de los componentes eléctricos;...
(ver figura 5) de pared, a continuación desmontar el panel. Prestar atención a las aletas del condensador porque tienen filo. figura 5 5 Enjuagar con bebida fresca para eliminar todo residuo posible de solución para higienizar del fondo de los contenedores.
Página 10
ARCTIC DELUXE SERIES SPARE PARTS LIST DESCRIPCION PIEZAS DE REPUESTO...
Página 11
2408_49 V 0.4 08A09 5.4gal It bowl cover Tapa contenedor 5.4gal 00651 3.17gal bowl cover Tapa contenedor 3.17gal 00651 Bowl gasket Junta contenedor 00653 Plastic I-beam for connection Perfil de union 00655 Central pivot Pivote central 00656 Central pivot OR OR del pivote central 00112 Motor magnet...