Installing/Removing Battery Pack - Ryobi P239 Manual Del Operador

WARNING:
Battery tools are always in operating condition. Lock the
switch when not in use or carrying at your side, when
installing or removing the battery pack, and when install-
ing or removing bits.
INSTALLING/REMOVING BELT CLIP
See Figure 2, page 9.
The belt clip may be installed on either side of the housing.
 Squeeze the prongs together as shown.
 Insert the prongs into the belt hook slot on either side of
the tool.
 When the belt hook is fully inserted into the slot, release
the prongs.
 To remove, squeeze the prongs together and pull the belt
hook out of the slot on the side of the tool.

INSTALLING/REMOVING BATTERY PACK

See Figure 3, page 9.
 Lock the switch trigger.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
INSTALLING/REMOVING BITS
See Figure 4, page 10.
To install:
 Lock the switch trigger by placing the direction of rotation
selector in center position.
 Remove the battery pack.
 Slide the coupler forward and hold it in this position.
 Insert bit straight into coupler.
 Slide the coupler back slowly and release.
NOTE: MAINTENANCE INSTRUCTIONS BEGIN ON PAGE 8
FOLLOWING FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
ILLUSTRATIONS START ON PAGE 9.
7 — English
To remove bits:
 Lock the switch trigger.
 Remove the battery pack.
 Slide the coupler forward and hold in position.
 Pull the bit straight out of the coupler.
WARNING:
Make sure the bit is secured in the coupler before using
the impact driver. Failure to do so could cause serious
personal injury.
CAUTION:
The metal surface may become hot during use. Avoid
contact with it to avoid possible burn injury.
DRIVING OR REMOVING SCREWS
See Figures 5 - 6, page 10.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock
the operator. If you must drive a screw where hidden wire
could be present, always hold tool by insulated gripping
surfaces (handle) when performing the operation to pre-
vent a shock to the operator.
NOTICE:
The impact driver is not designed to be used as a drill.
 Place the direction of rotation selector in the correct posi-
tion for operation.
 Hold the impact driver with one hand.
 Place the bit on the screw head and slowly depress the
switch trigger. Start the bit slowly for more control.
NOTE: The LED will illuminate as the trigger is depressed.
 As the screw is driven, impacting will begin.