Features; Assembly - Ryobi RYAXA22 Manual Del Operador

KNOW YOUR BLOWER ATTACHMENT
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
UNPACKING
This product requires assembly.
 Carefully remove the items from the box. Make sure that
all items listed in the Packing List are included.
WARNING:
Do not use this product if any parts in the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Blower Attachment
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.

FEATURES

PRODUCT SPECIFICATIONS
Blowing Performance (at Nozzle Outlet):
MPH (peak velocity) ................................................ 140
MPH (average velocity) ........................................... 120
CFM ........................................................................ 475
Measured at the blower tube outlet per ANSI B175.2 standard for
measuring blower performance with a RYOBI 2 Cycle Power Head

ASSEMBLY

WARNING:
This product is intended for blower use only and is not
designed for vacuum use. Do not attempt to remove the
main reducer housing that covers the impellers. Removal
of the main reducer housing will expose the moving im-
pellers and contact with these impeller blades can result
in serious personal injury.
WARNING:
Do not connect to power head until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
JOINING THE POWER HEAD TO THE
BLOWER ATTACHMENT
See Figure 2.
WARNING:
Never attach or adjust any attachment while power head
is running. Failure to stop the engine or motor may cause
serious personal injury.
Install the blower attachment onto the power head using
the coupler device.
 Remove the spark plug wire or disconnect from the power
supply.
 Remove the hanger cap from the attachment shaft.
 Loosen the knob on the coupler of the power head shaft.
 Push in the button located on the blower attachment.
Align the button with the guide recess on the power head
coupler and slide the two shafts together. Rotate attach-
ment shaft until button locks into the positioning hole.
NOTE: If the button does not release completely in the
positioning hole, the shaft is not locked into place. Slightly
rotate from side to side until the button is locked into
place.
 Tighten the knob securely.
5 — English