MENSA HEATING Imus Instrucciones De Uso página 40

• Do not use this heater with a programmer, timer or any other device that switches the
UK
heater on automatically, since a fire risk exists if the heater is covered or positioned
incorrectly.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capacity unless they are supervised and instructed by a
person who is responsible for their safety.
• RISK OF LOSS OF LIFE AND ACCIDENT TO INFANTS AND CHILDREN!
Never leave children unsupervised with the packaging materials or the product. There is a
risk of suffocation and loss of life from electric shock.
Maintenance and cleaning
• Disconnect the plug from the socket before cleaning or when the product is not in use for
prolonged periods of time.
• Do not clean the product until 60 minutes after it is turned off.
• When cleaning, do not spray cleaners or water directly into the product.
• Apply the cleaner on a cloth and wipe the product.
• For cleaning of reflector plate, please remove the grills. Clean the reflector plate with a
rag with glass cleaner, please DO NOT TOUCH the lamp with fingers or the cloth.
• For cleaning of the grills, please remove the grills. Clean the grills with a cloth with glass
cleaner.
• Regular maintenance of the product is recommended, as this will prolong the product's
service life and appearance (in coastal areas, the product should cleaned more
frequently, due to atmospheric salinity).
• Regularly check the cord for damages and ensure that the plug is clean.
• If the power cord, lamp or other electrical parts needs replacing, this must be done only
by a qualified professional.
Troubleshooting
Follow the troubleshooting steps listed below:
• Make sure the power cord is connected correctly.
• Check the cable for any ruptures.
• Make sure the On/ Off switch has been pressed.
• Check whether the bulb has blown.
• If the product is turned off due to overheating caused by improper use (overheat
Please contact the place of purchase if this did not solve your problem.
sensor), the product must be disconnected from the socket outlet and cool off.
Check the product for defects after 30 minutes of cooling. If there are no visible
defects, try to reconnect the product again.
4
2
Page 40