Advisory #2: Proper product selection
Product selection is an important element of fall protection. Fall
Arrest products are like any other tools that you may use in the
course of your work – there is a proper tool for every application.
You may find that while this product is suitable for some
applications, it may not be suitable for others. Please be sure to
pay close attention to sections 2, 3, and 4, for greater detail on this
point.
Advisory #3: Connector Compatibility
Making compatible connections may mean the difference
between life and death. Connectors (snap hooks, rebar hooks and
carabiners), must be of the locking type and require two distinct
actions to open the gate. Your connectors must be sized and
shaped so that the rings or structural members to which they are
attached will not pose a risk of forcing the gate open, and must fully
captivate the connector so that it cannot become disengaged, slide
or shift during use or in the event of a fall.
Certain connections are forbidden and should never be
attempted with this product or any other unless there is a specific
allowance in the manufacturer's instructions. Forbidden
connections include, but are not limited to:
Two or more connectors to one d-ring are a forbidden
connection.
A connection that rests on or loads the gate is a forbidden
connection.
A connection that does not allow the gate to close and lock
is a forbidden connection.
Two or more connectors attached to one another are a
forbidden connection.
Connecting directly to webbing, rope, cable (wire rope) is a
forbidden connection.
Connecting directly to a horizontal lifeline is a forbidden
connection.
Tie-back with your FallTech Web SRL is a forbidden
connection.
Connecting to any ring or structure that does not fully
captivate and completely restrict the movement your
connector is a forbidden connection.
7
Section 2: ABCD's
Every Personal Fall Arrest System consists of four basic elements –
Anchorage, Body-wear, Connectors/Connecting Devices and
Deceleration Devices. Each of these four elements is discussed in
greater detail below. If, after reading though this section, you do not fully
understand these items and how they work together to form a compatible
fall arrest system, please be sure to have this explained to you by a
Competent Person.
It is absolutely critical that you be familiar with the proper wear and/or
use of each component of your Personal Fall Arrest System (PFAS).
Failure to read, understand and adhere to instructional materials and
warnings provided with each of these components could lead to a
catastrophic failure of your PFAS, resulting in serious injury or death.
2.1: Anchorage
The selection of an anchor point and anchorage connector is critical
to the successful function of any Personal Fall Arrest System (PFAS).
OSHA 1926.502 (d) (15) states that:
"Anchorages used for attachment of personal fall arrest equipment shall
be independent of any anchorage being used to support or suspend
platforms and capable of supporting at least 5,000 pounds (22.2 kN) per
employee attached, or shall be designed, installed, and used as follows:
as part of a complete personal fall arrest system which maintains a
safety factor of at least two; and under the supervision of a qualified
person."
Ensure that the structure to which you are attaching your anchorage
connector is capable of meeting the above requirements and that your
anchorage connector is installed in accordance with the manufacturer's
instructions. Also be sure to check that the anchorage connector is
compatible with your FallTech Webr SRL and that it securely retains the
SRL without inhibiting its function. If you are unable to determine
whether your SRL and your anchorage are compatible, please
immediately consult with a competent person or your immediate
supervisor. For more details on anchorages, please see section 5 of this
instruction manual.
2.2: Body-wear
Body wear for any application where this SRL is to be used will be
defined as a full body harness specifically manufactured for fall arrest.
8