Open The Door - Fermax MEMOKEY Manual De Instalador

KEYPAD MODULE TEST
This kit is programmed at the factory with 3 default codes.
The preprogrammed codes are different for each unit, therefore you are the only one to
know them.
You can use this codes to test the equipment operation as well.
To test the code, dial the the one corresponding to the device you want to verify.
ACTION
CODE
CODE 1 (*)

OPEN THE DOOR

CODE 2 (*) ACTIVATE THE AUXILIARY DEVICE (if any)
CODE 3 (*)
BOTH OPEN THE DOOR AND ACTIVATE THE AUXILIARY DEVICE
(*) These codes are shown in a sticker in the back side of the panel controller.
Code 97572, V03_10
Technical publication of an informative nature published by FERMAX ELECTRONICA S.A.E.
As part of its policy of constant improvement, FERMAX ELECTRONICA S.A.E. reserves the
right to modify the content of this document and the characteristics of the products referred
to in it at any time and without prior notice.
Any modification will be reflected in subsequent editions of this document.
ENGLISH
Page 2